PPM 300 Shaft generator controller
Contact usThe PPM 300 Shaft generator controller variant controls and protects the system when a shaft generator is connected, and it controls and protects the shaft generator breaker.
When a shaft generator is connected, it is normally the ship's only power source, but it can run in parallel with the gensets and supply a base load for an extended period (long-time parallel). In such cases, the PPM 300 Shaft generator controller works with the PPM 300 Genset controllers to ensure efficient power management.
A DEIF power management system can include as many Shaft generator controllers as necessary.
Recommended I/O modules
Slot 1 |
Slot 2 |
Slot 3 |
Slot 4 |
Slot 5 |
Slot 6 |
Slot 7 |
PSM3.1 |
ACM3.1 |
IOM3.1 |
Blind module |
Blind module |
Blind module |
PCM3.1 |
The table shows a 7-slot rack, but the controller is also available with a 4-slot rack. Modules PSM3.1, ACM3.1, and PCM3.1 are mandatory. If you add expansion module racks, each expansion rack must contain a PSM3.2 power supply module but does not need to contain other modules.
For general information about the PPM 300 controller range and its modular architecture, see the PPM 300 main page.
Other PPM 300 variants
Product videos
Products
Installing the display unit (DU 300)
Introduction to the display unit (DU 300)
Introduction to the PPM 300 controller rack
Protection and Power Management (PPM 300)
Unboxing the display unit (DU 300)
Unboxing the PPM 300
Tutorials
Installing the Multi-line 300 controller rack
Cases
Ferry saves 30 % on fuel consumption